ho ricompilato il kernel 2.4.26 ma la risposta è sempre la stessa:
Description: hp laserjet 4050n
Location:
Printer State: processing, accepting jobs.
"Printer not connected; will retry in 30 seconds..."
Device URI: parallel:/dev/unknown-parallel0
ho anche decommentato diverse cose in: /etc/rc.d/rc.modules
#### PC parallel port support ###
#if cat /proc/ksyms | grep "\[parport_pc\]" 1> /dev/null 2> /dev/null ; then
# echo "parport0 is built-in, not loading module" > /dev/null
#else
# if [ -r /lib/modules/$RELEASE/misc/parport_pc.o \
# -o -r /lib/modules/$RELEASE/misc/parport_pc.o.gz \
# -o -r /lib/modules/$RELEASE/kernel/drivers/parport/parport_pc.o \
# -o -r /lib/modules/$RELEASE/kernel/drivers/parport/parport_pc.o.gz ]; then
# # Generic setup example:
/sbin/modprobe parport_pc
# # Hardware specific setup example (required for PLIP and better
# # performance in general):
/sbin/modprobe parport_pc io=0x378 irq=7
# fi
#fi
#### Parallel printer support ###
#if cat /proc/ksyms | grep "\[lp\]" 1> /dev/null 2> /dev/null ; then
# echo "lp support built-in, not loading module" > /dev/null
#else
# if [ -r /lib/modules/$RELEASE/misc/lp.o \
# -o -r /lib/modules/$RELEASE/misc/lp.o.gz \
# -o -r /lib/modules/$RELEASE/kernel/drivers/char/lp.o \
# -o -r /lib/modules/$RELEASE/kernel/drivers/char/lp.o.gz ]; then
/sbin/modprobe lp
# fi
#fi
### Filesystem Quota support ###
if grep -q quota /etc/fstab ; then
# modprobe quota_v1
modprobe quota_v2
fi
### Parallel port IP ###
/sbin/modprobe plip
qualquno può aiutarmi a risolvere?
grazie in anticipo