salve a tutti,

La Motherboard in questione č la - P6V8601A/A6B
di cui Questi i suoi Drivers

La domanda di aiuto č la seguente:
una volta scaricati i drivers, mi trovo due file... + un txt di spiegazione...

- A6_V17.BIN
- AWDFLASH.EXE

il txt di speigazione č questo:
/////////////////////// init
codice:
P6V8601A/A6 & P6V8601A/A6B & P6V8601A/A6E & P6V8602/A6T BIOS V1.7PMH release note.
 
This disk contains three files:A6_V17.BIN,README.TXT and AWDFLASH.EXE

1.The checksum of A6_V17.BIN is 90F9(Hex) ;

2. How to use AWDFLASH.EXE utility:
   This is a flash memory write/read utility.
IMPORTANT NOTE:
   The AWDFLASH utility could not correctly run in windows (virtual 8086)
   MS-DOS mode. It must be proceeded with the following steps:
      1.Create a bootable system floppy diskette by typing "FORMAT A:/S"
        from the dos prompt under DOS6.XX or WINDOWS9X environment.
      2.Boot system with diskette.
      3.Then run the AWDFLASH utility.
Usage:
      AWDFLASH [BIOSfile1] [BIOSfile2] [/<sw>[/<sw>...]]
     BIOSfile1: New BIOS Name For FLASH Programming
     BIOSfile2: BIOS File For Backing-up the Original BIOS

 <command> function definition:
      /cc: clear CMOS;        /cp: clear PnP;        /cd: clear DMI.
      /sn: No Original BIOS Backup. If this option is chosen:
         Be sure your new BIOS is compatible with your M/B. If not, the system 
         are damaged.
      /sy: Backup Original BIOS to Disk File.
 Examples:
        AWDFLASH ****.BIN /py/sn/cd/cp

 Warning: 
   Avoid power-off incidently in upgrading procedure, or system would fail
   to reboot!

UPDATE DATE:11/21/2001
///////////////// end


non mi č chiaro come questo Floppy dovrebbe eseguire l'aggiornamento necessario.

Pare non funzioni!!

Forse il modo in cui lo creo... (prendo i due file .exe e .bin e li salvo sul floppy)

Non solo, ma una volta che io ho impostato il Bios al Boot, quando vado a riavviare la macchina, mi dice di rimuovere il floppy per proseguire...

Grazie a tutti