Nel configurare un router ADLS 837 CISCO ho digitato SETUP ed e' partito il setup automatico.
Ho seguito passo passo le istruzioni il risultato e' questo :

access to the router over a network interface.
Enter virtual terminal password: mka223
Configure SNMP Network Management? [no]: no

Current interface summary

Interface IP-Address OK? Method Status Prot
ocol
ATM0 unassigned YES manual up up

Dialer1 82.53.94.166 YES IPCP up up

Ethernet0 192.168.1.1 YES manual up up

FastEthernet1 unassigned YES unset up up

FastEthernet2 unassigned YES unset down down

FastEthernet3 unassigned YES unset up up

FastEthernet4 unassigned YES unset down down

Virtual-Access1 unassigned YES unset up up

Virtual-Access2 unassigned YES unset up up


Enter interface name used to connect to the
management network from the above interface summary:
% No defaulting allowed

Enter interface name used to connect to the
management network from the above interface summary: ethernet
Invalid interface


Enter interface name used to connect to the
management network from the above interface summary: ethernet0

Configuring interface Ethernet0:
Configure IP on this interface? [yes]: yes
IP address for this interface [192.168.1.1]:
Subnet mask for this interface [255.255.255.0] :
Class C network is 192.168.1.0, 24 subnet bits; mask is /24

The following configuration command script was created:

hostname route
enable secret 5 $1$y292$zMqfAhj0/eTdWw.J2imcU1
enable password 0 Solt11
service password-encryption
line vty 0 4
password 0 mka223
no snmp-server
!
no ip routing

!
interface ATM0
shutdown
no ip address
!
interface Ethernet0
no shutdown
ip address 192.168.1.1 255.255.255.0
!
interface FastEthernet1
shutdown
no ip address
!
interface FastEthernet2
shutdown
no ip address
!
interface FastEthernet3
shutdown
no ip address
!
interface FastEthernet4
shutdown
no ip address
!
end


[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Connessione all'host perduta.

Ora non riesco piu a connettermi al router
Da cosadipende?
Vi prego aiutatemi..
Grazie in anticipo