Ho installato una scheda wireless (Netgear WG311v3) sul mio muletto. Installato driver con ndiswrapper. La situazione è questa (ho sostituito con delle X i mac address):

codice:
ferro:/# ifconfig wlan0
wlan0     Link encap:Ethernet  HWaddr XX:XX:XX:XX:XX:XX
          inet addr:192.168.1.11  Bcast:192.168.1.255  Mask:255.255.255.0
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:11 Memory:e8010000-e8020000

ferro:/# iwlist wlan0 scan
wlan0     Scan completed :
          Cell 01 - Address: XX:XX:XX:XX:XX:XX
                    ESSID:"SMC_WIFI"
                    Protocol:IEEE 802.11g
                    Mode:Managed
                    Frequency:2.442 GHz (Channel 7)
                    Quality:43/100  Signal level:-68 dBm  Noise level:-96 dBm
                    Encryption key:off
                    Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 22 Mb/s
                              6 Mb/s; 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s
                              36 Mb/s; 48 Mb/s; 54 Mb/s
                    Extra:bcn_int=200
                    Extra:atim=0
Ma se provo a dare:

codice:
ferro:/# ifup wlan0
Ignoring unknown interface wlan0=wlan0.
e non si connette, infatti se pingo il mio router mi dice "Destination Host Unreachable"
Dal comando route:

codice:
ferro:/# route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.1.0     *               255.255.255.0   U     0      0        0 eth0
192.168.1.0     *               255.255.255.0   U     0      0        0 wlan0
default         192.168.1.1     0.0.0.0         UG    0      0        0 eth0
Non è che devo specificare una route per wlan0? Ma come faccio?

Help...