Originariamente inviato da alkat
c'è un modo per rilevare la velocità dell'hd da linux?

.a.
Per la velocità, non saprei, ma molte informazioni si trovano sotto /proc/ide.
Esempio, da me:
codice:
[sergio@winnie ~]$ cat /proc/ide/amd74xx 
----------AMD BusMastering IDE Configuration----------------
Driver Version:                     2.13
South Bridge:                       nVidia Corporation nForce2 IDE
Revision:                           IDE 0xa2
Highest DMA rate:                   UDMA133
BM-DMA base:                        0xf000
PCI clock:                          33.3MHz
-----------------------Primary IDE-------Secondary IDE------
Prefetch Buffer:              yes                 yes
Post Write Buffer:            yes                 yes
Enabled:                      yes                 yes
Simplex only:                  no                  no
Cable Type:                   80w                 40w
-------------------drive0----drive1----drive2----drive3-----
Transfer Mode:       UDMA       DMA      UDMA       DMA
Address Setup:       30ns      90ns      30ns      90ns
Cmd Active:          90ns      90ns      90ns      90ns
Cmd Recovery:        30ns      30ns      30ns      30ns
Data Active:         90ns     330ns      90ns     330ns
Data Recovery:       30ns     270ns      30ns     270ns
Cycle Time:          15ns     600ns      60ns     600ns
Transfer Rate:  133.3MB/s   3.3MB/s  33.3MB/s   3.3MB/s
Altri files, riportano altre informazioni, più o meno specifiche.

ciao