In quello che naviga ho

root@Knoppix:/home/giorgio# ifconfig
eth0 Link encap:Ethernet HWaddr 00:02:A5:9D:FA:74
inet addr:192.168.1.77 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::202:a5ff:fe9d:fa74/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:6531 errors:0 dropped:0 overruns:0 frame:0
TX packets:5938 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2694784 (2.5 MiB) TX bytes:1081956 (1.0 MiB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:166 errors:0 dropped:0 overruns:0 frame:0
TX packets:166 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:11556 (11.2 KiB) TX bytes:11556 (11.2 KiB)

ppp0 Link encap:Point-to-Point Protocol
inet addr:87.9.65.127 P-t-P:192.168.100.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1
RX packets:6011 errors:0 dropped:0 overruns:0 frame:0
TX packets:5344 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:2490256 (2.3 MiB) TX bytes:923357 (901.7 KiB)

root@Knoppix:/home/giorgio#


cat /etc/resolv.conf

nameserver 85.37.17.41

nameserver 85.38.28.83


e quello che non naviga ...

eth0 192.168.1.4

nameserver 87.9.65.127

Un'altra cosa, come si fa a configurare il nat ?

CON 192.168.1.1 entro in una pagina "di stato" in cui è possibile configurare solo il WiFi, ma non c'è la voce per accedere alla configurazione del resto: Come si Fa ?

Grazie ancora.