pavars Set/get temp PA parameters
usage: wl down
wl pavars pa2gw0a0=0x1 pa2gw1a0=0x2 pa2gw2a0=0x3 ...
wl pavars
wl up
override the PA parameters after driver attach(srom read), before diver up
These override values will be propogated to HW when driver goes up
PA parameters in one band range (2g, 5gl, 5g, 5gh) must all present if
one of them is specified in the command, otherwise it will be filled with 0


povars Set/get temp power offset
usage: wl down
wl povars cck2gpo=0x1 ofdm2gpo=0x2 mcs2gpo=0x3 ...
wl povars
wl up
override the power offset after driver attach(srom read), before diver up
These override values will be propogated to HW when driver goes up
power offsets in one band range (2g, 5gl, 5g, 5gh) must all present if
one of them is specified in the command, otherwise it will be filled with 0
cck(2g only), ofdm, and mcs(0-7) for NPHY are supported




Mi esce questo nella guida, non so se ti può essere di aiuto...