Ho scaricato HDDScan dal sito ufficiale come viene detto alla fine di questa pagina dove vedi come si presenta HDDScan: http://www.wikihow.it/Correggere-l%2...clico-dei-Dati.
Ho cliccato su S.M.A.R.T. e cosa dovrebbe fare? Anche riparare tutti gli errori?
Ho avuto subito questo report:

HDDScan S.M.A.R.T. Report
Model: TOSHIBA MQ01UBD100
Firmware: AX001U
Serial: 35T3TJSWT
LBA: 1953525168

Report By: HDDScan for Windows version 3.3
Report Date: 15/06/2017 00.16.13


Num Attribute Name Value Worst Raw(hex) Threshold

001 Raw Read Error Rate 100 098 0000000000-0000 050

002 Throughput performance 100 100 0000000000-0000 050

003 Spin Up Time 100 100 0000000000-0B03 001

004 Start/Stop Count 100 100 0000000000-124E 000

005 Reallocation Sector Count 001 001 0000000000-3FF8 050

007 Seek Error Rate 100 100 0000000000-0000 050

008 Seek time Perfomance 100 100 0000000000-0000 050

009 Power-On Hours Count 091 091 0000000000-0F99 000

010 Spin Retry Count 193 100 0000000000-0000 030

012 Device Power Cycle Count 100 100 0000000000-03A3 000

191 G-sense Rate/Servo tracking 100 100 0000000000-0082 000

192 Emergency Retract Count 100 100 0000000000-001C 000

193 Load/unload Cycle Count 100 100 0000000000-1792 000

194 HDA Temperature 100 100 36 C 000

194 HDA Temperature Maximum 100 100 53 C 000

194 HDA Temperature Minimum 100 100 18 C 000

196 Reallocation Event Count 100 100 0000000000-03C9 000

197 Current Pending Errors Count 100 100 0000000000-0000 000

198 Uncorrectable Errors Count 100 100 0000000000-0000 000

199 UltraDMA CRC Errors 200 253 0000000000-0000 000

220 Disk Shift 100 100 0000000000-0000 000

222 Loaded Hours 100 100 0000000000-00CD 000

223 Load Retry Count 100 100 0000000000-0000 000

224 Load Friction 100 100 0000000000-0000 000

226 Load-in Time 100 100 0000000000-010B 000

240 Heads Flying Hours 100 100 0000000000-0000 001