dmesg:
input: PS/2 Synaptics TouchPad on isa0060/serio2
input: PS/2 Generic Mouse on isa0060/serio4

lsmod:
...
evdev 7296 0
...

Xorg.conf:

.....
Section "InputDevice"

# Identifier and driver

Identifier "Mouse1"
Driver "mouse"

# On platforms where PnP mouse detection is supported the following
# protocol setting can be used when using a newer PnP mouse:

# Option "Protocol" "Auto"

# The available mouse protocols types that you can set below are:
# Auto BusMouse GlidePoint GlidePointPS/2 IntelliMouse IMPS/2
# Logitech Microsoft MMHitTab MMSeries Mouseman MouseManPlusPS/2
# MouseSystems NetMousePS/2 NetScrollPS/2 OSMouse PS/2 SysMouse
# ThinkingMouse ThinkingMousePS/2 Xqueue
Option "Protocol" "PS/2"

# The mouse device. The device is normally set to /dev/mouse,
# which is usually a symbolic link to the real device.

Option "Device" "/dev/mouse"
# Option "Device" "/dev/psaux"
# Option "Device" "/dev/ttyS0"
# Option "Device" "/dev/ttyS1"

# When using XQUEUE, comment out the above two lines, and uncomment
# the following line.

# Option "Protocol" "Xqueue"

# Baudrate and SampleRate are only for some Logitech mice. In
# almost every case these lines should be omitted.

# Option "BaudRate" "9600"
# Option "SampleRate" "150"

# Emulate3Buttons is an option for 2-button Microsoft mice
# Emulate3Timeout is the timeout in milliseconds (default is 50ms)

# Option "Emulate3Buttons"
# Option "Emulate3Timeout" "50"

# ChordMiddle is an option for some 3-button Logitech mice

# Option "ChordMiddle"

EndSection


Section "InputDevice"
Identifier "Synaptics Mouse"
Driver "synaptics"
Option "Device" "/dev/psaux"
Option "Protocol" "auto-dev"
Option "LeftEdge" "1700"
Option "RightEdge" "5300"
Option "TopEdge" "1700"
Option "BottomEdge" "4200"
Option "FingerLow" "25"
Option "FingerHigh" "30"
Option "MaxTapTime" "180"
Option "MaxTapMove" "220"
Option "VertScrollDelta" "100"
Option "MinSpeed" "0.06"
Option "MaxSpeed" "0.12"
Option "AccelFactor" "0.0010"
Option "SHMConfig" "on"
# Option "Repeater" "/dev/ps2mouse"
EndSection
.....

Section "ServerLayout"

# The Identifier line must be present
Identifier "Simple Layout"

# Each Screen line specifies a Screen section name, and optionally
# the relative position of other screens. The four names after
# primary screen name are the screens to the top, bottom, left and right
# of the primary screen. In this example, screen 2 is located to the
# right of screen 1.

Screen "Screen 1"

# Each InputDevice line specifies an InputDevice section name and
# optionally some options to specify the way the device is to be
# used. Those options include "CorePointer", "CoreKeyboard" and
# "SendCoreEvents".

InputDevice "Mouse1" "AlwaysCore"
InputDevice "Synaptics Mouse" "AlwaysCore"
InputDevice "Keyboard1" "CoreKeyboard"

EndSection
...

Dal log Xorg.0.log:

.............
(**) Option "Protocol" "PS/2"
(**) Mouse1: Device: "/dev/mouse"
(**) Mouse1: Protocol: "PS/2"
(**) Option "AlwaysCore"
(**) Mouse1: always reports core events
(**) Option "Device" "/dev/mouse"
(==) Mouse1: Emulate3Buttons, Emulate3Timeout: 50
(==) Mouse1: Buttons: 3
(II) Synaptics touchpad driver version 0.13.5
Synaptics Mouse no synaptics event device found (checked 4 nodes)
(**) Option "Device" "/dev/psaux"
(**) Option "SHMConfig" "on"
(**) Option "LeftEdge" "1700"
(**) Option "RightEdge" "5300"
(**) Option "TopEdge" "1700"
(**) Option "BottomEdge" "4200"
(**) Option "FingerLow" "25"
(**) Option "FingerHigh" "30"
(**) Option "MaxTapTime" "180"
(**) Option "MaxTapMove" "220"
(**) Option "VertScrollDelta" "100"
Query no Synaptics: 6003C8
(EE) Synaptics Mouse no synaptics touchpad detected and no repeater device
(EE) Synaptics Mouse Unable to query/initialize Synaptics hardware.
(EE) PreInit failed for input device "Synaptics Mouse"
(II) UnloadModule: "synaptics"
(II) Keyboard "Keyboard1" handled by legacy driver
(**) Mouse1: Device: "/dev/mouse"
(**) Mouse1: Protocol: "PS/2"
(**) Option "CorePointer"
(**) Mouse1: Core Pointer
(**) Option "Device" "/dev/mouse"
(==) Mouse1: Emulate3Buttons, Emulate3Timeout: 50
(==) Mouse1: Buttons: 3
(II) XINPUT: Adding extended input device "Mouse1" (type: MOUSE)
(II) XINPUT: Adding extended input device "Mouse1" (type: MOUSE)
(II) Mouse1: ps2EnableDataReporting: succeeded
(II) Mouse1: ps2EnableDataReporting: succeeded
Could not init font path element /usr/X11R6/lib/X11/fonts/local, removing from list!
Could not init font path element /usr/X11R6/lib/X11/fonts/CID, removing from list!
Could not init font path element /usr/share/fonts, removing from list!
Could not init font path element /usr/X11R6/lib/X11/fonts, removing from list!
Could not init font path element /usr/share/fonts/default, removing from list!
Could not init font path element /usr/share/fonts/default/Type1, removing from list!
SetClientVersion: 0 8
..............

Non sarà supportato il mio modello??