Allora ti spiego cosa vorrei fare:
In casa mia sto usando un router della ravo(quello famoso che non mi fa scaricare in ftp)e alla porta wan un modem d-link,
pc collegati con internet da questo router e in rete.
Vorrei tentare di portare la rete internet a una distanza di 2 km.
Ho aquistato un access point netgear a 11/mbps con questo access point vorrei colllegare un pc portatile in rete e in internet.

Nel mio router ho capito che devo mettere il mac del access point netgear, poi nel setaggio del access point devo mettere lo stesso nome della rete e le stesse chiavi wep fino a qua credo di non essermi sbagliato poi in caso contrario me lo dirai.

Il problema sono questi settaggi del access point pur conoscendo la lingua inglese in modo discreto non capisco quale settaggio fa al caso mio io ti riporto tali settaggi se puoi dirmi che settaggio e quello corretto per me . Almeno se non funziona so che il problema e un altro.

Allego tali settaggi grazie:


Wireless Access Point - Operate as a standard 802.11b or 802.11x Access Point.

Point-to-Point Bridge - In this mode, the ME103 will communicate ONLY with another Bridge-mode Wireless Station. You must enter the MAC address (physical address) of the other Bridge-mode Wireless Station in the field provided. WEP can (and should) be used to protect this communication.

Point-to-Multi-Point Bridge
- Select this only if this ME103 is the "Master" for a group of Bridge-mode Wireless Stations. The other Bridge-mode Wireless Stations must be set to Point-to-Point Bridge mode, using this ME103's MAC address. They then send all traffic to this "Master", rather than communciate directly with each other. WEP can (and should) be used to protect this traffic.

Client Access Point - Select this if you wish this AP to act as a Client Access Point (CAP) for a remote GAP. If selected, you must enter the MAC address (physical address) of the remote GAP.
Repeater Access Point - If selected, this AP will operate as a Repeater only, and send all traffic to the remote AP. If selected, you must enter the MAC address (physical address) of the remote AP.
In either of the Bridge modes: