tramite ndiswrapper ho installato i driver della mia scheda wireless apposta per x86_64, caricando il modulo ndiswrapper mi ritorna il seguente messaggio:

ndiswrapper version 1.2+CVS loaded (preempt=yes,smp=no)
ndiswrapper (load_pe_images:574): fixing KI_USER_SHARED_DATA address in the driver
ndiswrapper: driver neti2220x64 (,17/01/2005,3.03.12.2006) loaded
ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 21 (level, low) -> IRQ 21
ndiswrapper: using irq 21
wlan0: ndiswrapper ethernet device 00:0e:9b:8d:46:55 using driver neti2220x64, configuration file 17FE:2220.5.conf
wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP with WPA, WPA2, WPA2PSK



e fin qui tutto ok.

poi, per configurare la scheda wireless imposto così i comandi:

iwconfig wlan0 essid "mioessid"
iwconfig wlan0 mode managed
iwconfig wlan0 key s:miachiavewep
ifconfig wlan0 up
ifconfig wlan0 192.168.1.105



poi con iwconfig controllo wlan0:

wlan0 IEEE 802.11g ESSID:"mioessid"
Mode:Managed Frequency:2.462 GHz Access Point: 00:01:E3:04:F69
Bit Rate=54 Mb/s Tx-Power:0 dBm
RTS thrff Fragment thrff
Encryption key:xxxx-xxxx-xxxx-xxxx-xxxx-xxxx-xxxx-xx Security mode:restricted
Power Managementff
Link Quality:100/100 Signal level:-44 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:2 Missed beacon:0


da KWiFiManager vedo tutti i dati al posto giusto, mi dice che sono connesso alla mia rete, ip giusto, canale giusto e velocità giusta ma quando vado per dare dhcpcd wlan0
non mi fa niente, il prompt rimane fermo e wlan0 non si connette a internet, addirittura non riesco nemmeno a pingare il router. se pingo mi da:

# ping -I wlan0 192.168.1.101
PING 192.168.1.101 (192.168.1.101) from 192.168.1.105 wlan0: 56(84) bytes of data.
From 192.168.1.105 icmp_seq=1 Destination Host Unreachable
From 192.168.1.105 icmp_seq=2 Destination Host Unreachable
From 192.168.1.105 icmp_seq=3 Destination Host Unreachable

--- 192.168.1.101 ping statistics ---
5 packets transmitted, 0 received, +3 errors, 100% packet loss, time 4008ms, pipe 3

e da qui son fermo, idee