Il comando che mi hai consigliato dà l’esito seguente:

**********************************
[root@localhost userC]# /etc/rc.d/init.d/iptables stop
Azzerare le regole del firewall: [ OK ]
Impostazione delle catene su policy ACCEPT:filter [ OK ]
Scaricamento dei moduli iptables: [ OK ]
[root@localhost userC]#
**********************************

ho poi provato di nuovo a connettermi ma niente da fare, si connette ma il browser non funge

ti riporto altri output di comandi che ho provato

******************************************
[root@localhost userC]# ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1880 errors:0 dropped:0 overruns:0 frame:0
TX packets:1880 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1656260 (1.5 MiB) TX bytes:1656260 (1.5 MiB)

ppp0 Link encap:Point-to-Point Protocol
inet addr:217.201.130.89 P-t-P:10.6.6.6 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:57 errors:0 dropped:0 overruns:0 frame:0
TX packets:58 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:2999 (2.9 KiB) TX bytes:3411 (3.3 KiB)
************************************************** ****

ho anche dato il comando ifconfig eth0 down

ma niente da fare...

ti riporto la tabella getway (se ho capito bene vuoi che te la riporti nel messaggio?)

col comando route dà

Getway

[root@localhost userC]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.6.6.6 * 255.255.255.255 UH 0 0 0 ppp0
169.254.0.0 * 255.255.0.0 U 0 0 0 lo
default 10.6.6.6 0.0.0.0 UG 0 0 0 ppp0
[root@localhost userC]#
************************************************** *****

Ti riporto con più precisione la colonna gatetway

Geteway

*
*
10.6.6.6