Ok, sono un fagiano io che non avevo aggiunto il mac address della scheda tra i mac address consentiti dal router. Ora ho associato la scheda al router:
codice:
ferro:/# iwconfig wlan0
wlan0 IEEE 802.11g ESSID:"SMC_WIFI"
Mode:Managed Frequency:2.442 GHz Access Point: XX:XX:XX:XX:XX:XX
Bit Rate:6 Mb/s Sensitivity=-200 dBm
RTS thr:2346 B Fragment thr:2346 B
Encryption key:off
Power Management:off
Link Quality:31/100 Signal level:-76 dBm Noise level:-96 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Però non riesco ugualmente ad attivare l'interfaccia:
codice:
ferro:/# ifup wlan0
Ignoring unknown interface wlan0=wlan0.
e infatti se poi provo a pingare il router:
codice:
ferro:/# ping 192.168.1.1
PING 192.168.1.1 (192.168.1.1) 56(84) bytes of data.
From 192.168.1.11 icmp_seq=5 Destination Host Unreachable
--- 192.168.1.1 ping statistics ---
7 packets transmitted, 0 received, +1 errors, 100% packet loss, time 5999ms
Il router mi appare solo per l'interfaccia eth0 però. E' normale?
codice:
ferro:/# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
192.168.1.0 * 255.255.255.0 U 0 0 0 wlan0
default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0