beh, è vero, ma il mio dubbio sorge per due motivi:
- bloccando il processo il mulo funziona ugualmente;
- al fine di evitare un accesso incontrollato (trusted zone), avevo già impostato un protocollo di regole specifiche per il mulo, trovate direttamente sul forum ufficiale di comodo; queste per intendersi:
codice:
Regola 1
Action = Allow
Protocol = TCP
Direction = In
Description = Regola per il Protocollo TCP in Entrata
Source Address = Any
Destination Address = Any
Source port = (Range of ports) = 1024-65535
Destination port = la porta TCP di emule
Regola 2
Action = Allow
Protocol = UDP
Direction = In
Description = Regola per il Protocollo UDP in Entrata
Source Address = Any
Destination Address = Any
Source port = (Range of ports) = 1024-65535
Destination port = la porta UDP di emule
Regola 3
Action = Allow
Protocol = TCP
Direction = Out
Description = Regola per il Protocollo TCP in Uscita
Source Address = Any
Destination Address = Any
Source port = (Range of ports) = 1024-65535
Destination port = (Range of ports) = 1024-65535
Regola 4
Action = Allow
Protocol = UDP
Direction = Out
Description = Regola per il Protocollo UDP in Uscita
Source Address = Any
Destination Address = Any
Source port = UDP di eMule
Destination port = (Range of ports) = 1024-65535
Regola 5
Action = Ask (attivate l'opzione Log as a firewall event if this rule is fired)
Protocol = TCP
Direction = Out
Description = Regola per gli aggiornamenti
Source Address = Any
Destination Address = Any
Source port = (Range of ports) = 1024-65535
Destination port = 80
Regola 6
Action = Block (attivate l'opzione Log as a firewall event if this rule is fired)
Protocol = IP
Direction = In/OUT
Description = Blocca e registra tutte le richieste che non corrispondono
Source Address = Any
Destination Address = Any
IP Details = Any
...quindi in teoria il mulo doveva essere apposto. :master:
concedo l'accesso senza problemi...
Grazie.