in breve:
Geforce FX5200 su red hat 9
codice:
lspci -v
01:00.0 VGA compatible controller: nVidia Corporation:
Unknown device 0322 (rev a1) (prog-if 00 [VGA])
Flags: bus master, 66Mhz, medium devsel, latency 248, IRQ 11
Memory at e6000000 (32-bit, non-prefetchable) [size=16M]
Memory at e8000000 (32-bit, prefetchable) [size=128M]
Expansion ROM at e7fe0000 [disabled] [size=128K]
Capabilities: [60] Power Management version 2
Capabilities: [44] AGP version 3.0
codice:
bash-2.05b# cat /proc/driver/nvidia/agp/card
Fast Writes: Supported
SBA: Supported
AGP Rates: 8x 4x
Registers: 0x1f000e1b:0x1f000302
codice:
bash-2.05b# cat /proc/driver/nvidia/agp/status
Status: Enabled
Driver: NVIDIA
AGP Rate: 8x
Fast Writes: Disabled
SBA: Enabled
codice:
bash-2.05b# cat /proc/driver/nvidia/agp/host-bridge
Host Bridge: VIA Technologies, Inc. VT8377 [KT400 AGP] Host Bridge
Fast Writes: Supported
SBA: Supported
AGP Rates: 8x 4x
Registers: 0x1f000a1b:0x1f000b02
codice:
bash-2.05b# cat /proc/driver/nvidia/cards/0
Model: GeForce FX 5200
IRQ: 11
Video BIOS: 04.34.20.42.00
Card Type: AGP
codice:
#XF86config.conf
Section "Device"
Identifier "GeForce 5200"
Driver "nvidia"
VideoRam 131072
Option "RenderAccel" "true"
Option "DPMS" "on"
Option "EnablePageFlip" "true"
Option "AGPFastwrite" "true
Option "EnableDepthMoves" "true"
Option "RenderAccel" "true"
Option "NvAGP" "2"
Option "NoLogo" "true"
Option "HWCursor" "true"
Option "ConnectedMonitor" "CRT"
EndSection
su XF86config devo disabilitare load "glx" altrimenti non
parte (failed to load module glx)
tramite apt ho installato le patch per il kernel (un po
fedora like...):
codice:
bash-2.05b# uname -a
Linux ainex 2.4.20-43_41.rh9.at #1 Sun May 22 02:24:49 EDT
2005 i686 athlon i386 GNU/Linux
codice:
bash-2.05b# apt-cache search nvidia-graphics7667
nvidia-graphics7667 - NVIDIA Linux Display Driver.
nvidia-graphics7667-kmdl-2.4.20-43_41.rh9.at - Kernel module
for NVIDIA graphics architecture support.
nvidia-graphics7667-libs - Libraries for nvidia-graphics
chips.
Tutto va, ma non il glx. :master: