Ciao
sulla mia Slack 10 stò tentando di utilizzare la mia scheda video ATI RAGE 128, modificando il file xorg.conf, ma non ci riesco. Il modulo r128 viene caricato all'avvio, ma non viene utilizzato. Qualcuno mi sa dire dove sbaglio?
Section "Module"
# This loads the DBE extension module.
Load "dbe" # Double buffer extension
# This loads the miscellaneous extensions module, and disables
# initialisation of the XFree86-DGA extension within that module.
SubSection "extmod"
Option "omit xfree86-dga" # don't initialise the DGA extension
EndSubSection
# This loads the Type1 and FreeType font modules
Load "type1"
Load "speedo"
Load "freetype"
# Load "xtt"
# This loads the GLX module
Load "glx"
# This loads the DRI module
Load "dri"
EndSection
# Graphics device section
# ************************************************** ********************
# Any number of graphics device sections may be present
# Standard VGA Device:
Section "Device"
Identifier "ATI RAGE 128"
VendorName "Unknown"
BoardName "Unknown"
# The chipset line is optional in most cases. It can be used to override
# the driver's chipset detection, and should not normally be specified.
# Chipset "generic"
# The Driver line must be present. When using run-time loadable driver
# modules, this line instructs the server to load the specified driver
# module. Even when not using loadable driver modules, this line
# indicates which driver should interpret the information in this section.
Driver "r128"
# The BusID line is used to specify which of possibly multiple devices
# this section is intended for. When this line isn't present, a device
# section can only match up with the primary video device. For PCI
# devices a line like the following could be used. This line should not
# normally be included unless there is more than one video device
# intalled.
# BusID "PCI:0:10:0"
# VideoRam 256
# Clocks 25.2 28.3
EndSection
# Device configured by xf86config:
Section "Device"
Identifier "** ATI Rage 128 based (generic) [r128]"
Driver "r128"
#VideoRam 8192
# Insert Clocks lines here if appropriate
EndSection
# ************************************************** ********************
# Screen sections
# ************************************************** ********************
# Any number of screen sections may be present. Each describes
# the configuration of a single screen. A single specific screen section
# may be specified from the X server command line with the "-screen"
# option.
Section "Screen"
Identifier "Screen 1"
Device "** ATI Rage 128 based (generic) [r128]"
Monitor "Samsung Syncmaster 550"
DefaultDepth 24
Subsection "Display"
Depth 8
Modes "1280x1024" "1024x768" "800x600" "640x480"
ViewPort 0 0
EndSubsection
Subsection "Display"
Depth 16
Modes "1280x1024" "1024x768" "800x600" "640x480"
ViewPort 0 0
EndSubsection
Subsection "Display"
Depth 24
Modes "1280x1024" "1024x768" "800x600" "640x480"
ViewPort 0 0
EndSubsection
EndSection
Ad ogni tentativo di modifica, non si avvia il server x. Che fare?
Rispondi quotando
Niente da fare! Da glxinfo la risposta è sempre: direct rendering: no
